The first thing I did when I had all my supplies together ready to assemble the ornaments was make a black and white xerox copy of both designs. I cut out the paper copies so that they were the same size as my icons. (The photo above shows the pet guardian angel paper copies lying on one sheet of finishing foam. The second photo below shows a paper copy being cut.) Using a loop of Scotch tape, I stuck these paper templates onto my finishing foam and cut out the foam to the correct size. I did that twice as I need two piece of finishing foam for each ornament. The needlepoint goes over one piece of finishing foam and the black felt backing goes over the other.
So for the Red Madonna I had: one NP canvas, one paper copy, and two pieces of finishing foam. Ditto the Blue Angel: one NP canvas, one paper copy, and two more pieces of finishing foam.
Because I bought self-stick finishing foam, I peeled off the backing and stuck two foam pieces to the black felt, then cut out the felt with a little margin all around the edges. These two pieces of black felt will make the back side of my ornaments.
After than, I took the two remaining pieces of finishing foam, peeled off the paper backing and stuck them to the gold lame fabric. This time when I cut out the gold lame, I didn't leave any margin sticking out. These gold lame covered finishing foam sheets go behind my needlepoint with the gold lame facing out so that you can sort of see it in the empty holes of the gold background I didn't stitch. This adds sparkle to the Christmas ornaments and also hides the innards of the ornament from view.
The next step now that the finishing foam pieces are cut and glued to the fabrics, is to cut out your needlepoint, leaving a margin of about a half inch all the way around. (For my 14 count canvas I cut to within 7-8 threads of the stitched area.) With rectangles, this is really easy, unlike the pet guardian angel shapes which you see above. Those have curves which have to be clipped, etc. For your first project, I'd recommend a square or rectangle ornament as those are very easy shapes to cut out and then turn under. MAKE SURE you do not use your good embroidery scissors to cut the needlepoint canvas. That will dull the blades very quickly.
Once you have trimmed your needlepoint canvas, using your fingers press the raw edges under. The edges will stay sort of turned under on their own once you mash them. At the corners it is often easier to mitre the corners. That just means you turn under the corner so it looks like a triangle on the back side, then fold the top and side edges together. This website shows you how in Figures 1 and 2.
http://books.google.com/books?id=mgivU2XxDvUC&pg=PA15&lpg=PA15&dq=embroidery+how+to+mitre+corners+in+finishing&source=bl&ots=asqEzVSBwf&sig=gqQ0nlckzThFfhSWhNmT3bQe7AQ&hl=en&ei=qeY4SpmmMYOHtgfDqZ3jDA&sa=X&oi=book_result&ct=result&resnum=2
Or Tiny URL
http://tinyurl.com/lny3rv
That's enough for today. I estimate all the above takes about 60-90 minutes for two ornaments but I've done this many times. Your first attempt will take you longer, particularly if you are constantly interrupted as I usually am or if you have to pull together all your supplies from all over the house.
Jane/Chilly Hollow
Archived Yahoo 360 postings at http://profiles.yahoo.com/chillyhollow
No comments:
Post a Comment